Clean molds, tooling and equipment in place. No media. No chemicals. No tear-down.
We bring the laser to your plant, so parts stay in the press, on the line or on the wall. It's usually cheaper than pulling, shipping or blasting.


Before
After, same spot
OSHA 30 trained · ISNetworld & CCS certified · Father-and-son, Indianapolis
Rotational molds cleaned on-site in one shift
11 molds in 6.5 hrs
Under 40 min
Saved, not replaced
Rotational molds cleaned on-site in one shift
Rubber molds cleaned hot, still in the press
Fire-damaged joists cleaned instead of torn out
What we clean
Pick your job. Each page shows real results and how a visit works.



Rust & coating removal
Rust, paint and mill scale stripped to clean metal, no pitting.



Tanks & process equipment
Rouging, carbon and coatings off tanks, ovens and rollers.
Fire & soot restoration
Save charred joists, brick and stone instead of tearing them out.
Aerospace & precision parts
Oxidation and carbon off critical parts without changing tolerances.
How it works
1. Send a photo
Text or upload a picture of the part. We'll tell you within a day if laser is a fit, and if it isn't.
2. Test one part on-site
We clean one mold or section at your plant, timed against how you clean it now. You see the result before you commit.
3. We clean, you keep running
Scheduled around your shifts or shutdown. No media to clean up, no chemicals to dispose of.
Laser vs. the old way
Pull & hand-clean
Mold comes off the press. Tools scratch the surface. Solvents and rags. Hours of your crew's time per mold.
Blasting / dry ice
Often off the press. Media can erode edges over time. Media, noise and containment. Setup plus cleanup.
Laser Blasting Pros
Cleaned in place. Non-abrasive, no change to the part. No media, no chemicals. We do the work.
Common questions
Will the laser damage my mold?
No. It removes the contamination layer and stops at the base metal. We test a small spot first.
Are you approved to work in our plant?
Yes. We're OSHA 30 trained and ISNetworld and CCS certified, and we travel all of Indiana.
Does the mold have to come out of the press?
Usually not. Most molds are cleaned in place, including hot rubber molds.
